SmartReader 1 Accessories

With its wide range, it is ideal for sensing temperature in most applications. The temperature sensor is housed inside a stainless steel tip for fast response time.

Convenient and easy to install, it wraps around any pipe less than 2in(5cm) diameter. Fastens to any pipe with its Velcro® strapping system. No tools required.

A simple external sensor used to monitor skin temperature on humans and animals. To mount the sensor, simply use medical tape to adhere the sensor on to the skin of the subject.

For applications where the center of the temperature sensing point will be approximately 0°C. The temperature sensor is housed inside a stainless steel probe for fast response time.

For applications where the center of the temperature sensing point will be approximately 0°C. The temperature sensor is housed inside a stainless steel probe for fast response time.

For applications where the center of the temperature sensing point will be approximately 80C. The temperature sensor is housed inside a stainless steel tip for fast response time.

Temperature Probe For applications where the center of the temperature sensing point will be approximately 150°C. The temperature sensor is housed inside a tiny stainless steel tip for fast response time.

This waterproof (IP-67 rated) temperature sensor is 10k ohms and has a wide operating range. This sensor conforms to the same specifications as the ET-016 temperature sensor.

When multiple external sensors are connected to a SmartReader or SmartReader Plus Data Logger, this strain relief easily snaps on to the connector and locks all the wiring connections to the terminal block.

Leave terminal blocks connected to your sensors. No need to rewire your sensors in every time you use your data logger at a different location. Convenient and time saving.

Connect a SmartReader, SmartReader Plus or Nautilus to a Female DB9 Serial Port. Features: Convenient easy-to-connect Data Logger plug Easy troubleshooting  - echos characters for cable detection Attaches directly to SmartReader Plus network Benefits: No cumbersome connectors or special tools needed No special drivers or interface requirements  Lowest common denominator for hooking to serial devices  

Connect a SmartReader, SmartReader Plus or Nautilus to Universal Serial Bus Port.  Features: Convenient easy-to-connect Data Logger plug Driver registered with Microsoft - automatic cable detection Powers SmartReader Plus network directly from connection Benefits: No cumbersome connectors or special tools needed No agravating drivers to load or separate disks required No external power supply needed for multiple data loggers

Male-female extension cable for extending the length cable from data logger.

External modem for use on the PC factory programmed for communication with ACR Data Logger Networks.

Factory programmed external modem for use on an ACR Data Logger Network.

Required to link a single SmartReader Data Logger to a modem. Also required on any SmartReader Plus remote network. Adapts between the IC-101 and modem.

Protects loggers from dust and debris while allowing air flow to the logger. ideal for relative humidity loggers.

Ideal for washdown bays or other environments where condensation or other contaminants may contact your Data Logger. Has a metal backing inside to allow the logger to suspend magnetically inside. One external connection sealing system is supplied permitting use of external probes with logger. NEMA 4X rated. Holds up to 3 data loggers.

Use with the Weatherproof box to connect additional external sensors to a SmartReader or SmartReader Plus logger. Will seal up to a 1/4 inch diameter cable.

Protects the SmartReader stereo jack from dirt and debris.

A convenient way to protect and organize your ACR Data Logger investment. Rugged and stylish, the case is made from Polystyrene for years of solid protection. The inside layout can be customized since the foam is die cut. Key locks provide added security. Can hold up to 21 data loggers plus accessories.